Turkey Pot Call and Handle Mold - Maker Select HDPE Turkey Call Mold
Turkey Pot Call and Handle Mold - Maker Select HDPE Turkey Call Mold
Couldn't load pickup availability
Favorite Accessories
Maker Select HDPE Turkey Call Mold
This mold is for casting a turkey pot call blank and striker handle to match. The mold is made from precision machined HDPE.
To use cast your blank and let cure, Use demold rack and use air or punch to knock blank out.
Use with Alumilite Urethane resins only.
Measures approximately - 6.25" x 4.75" x 2"
Turkey Call Cavity measures approximately - 4" diameter x 1.25" deep
Turkey Handle Cavity measures approximately - 4" x 1.25" x 1.25" deep
How to determine resin needed for a rectangle or square mold (this is a good place to start, you should verify during pour and make adjustments in future) There is .554oz in 1 cubic inch of resin
liquid volume = ( length x width x height ) x .554
example- if your mold is 6" x 5.5" x 1" = 33 cubic inches
take 33 cubic inches x .554 ox per cubic inch = 18.28 oz
First time use demolding tip: If the blanks don't come out easily with air or a tap try whacking the mold upside down on the table. This creates some air behind the blanks and they should pop out more easily.
*Made in USA*
*blanks not included with this purchase*
Share


